Mopar Headpipe Kits 
Mopar Headpipe Kits
888-465-7260
All
Mopar Headpipe Kits come with Headpipes, any size Collector Reducers,
Kit A Balance Tube and all mounting
hardware, including muffler hangers for your vehicle. No-Weld Collector
Reducers may be substituted. In fact, in most cases, the No-Welds will be
necessary.
If the headers are not aiming straight towards the humps in the tranny crossmember, then the No-Weld Collector Reducers will be necessary. So when you place your order, you will need to tell us how your headers "aim" so we can include the correct reducers.
| 2.5" Headpipe Kits | ||
| Mopar A & B-Body | CCXH2500 | $182 |
|
Mopar E-Body |
CCXHE2500 | $182 |
| 3" Headpipe Kits | ||
| Mopar A & B-Body | CCXH3000 | $201 |
|
Mopar E-Body |
CCXHE3000 | $201 |
| Substitute Kit B Balance Tube with any of the above Kits | add $17 | |
| Add Pair of 3" Mandrel Bent Muffler Turn Downs (see below) | add $50 | |
| Add Drive Shaft Safety Loop | n/a | |
|
Stainless Clamp Upgrade |
||
| Above Headpipe Kits utilize 6 zinc U-Bolt Clamps | ||
| You can mix and match types of clamps. | ||
| 2.5" SS U-Bolt | $7.75 ea | |
| 3" SS U-Bolt | $9.75 ea | |
| 2.5" & 3" SS Band Clamps | $7.75 ea | |
| Mufflers for Above per pair | ||
|
|
||
MUFFLER TURNDOWNS
Helps deflect exhaust downward away from the rear end area. Safer and some quieter. Muffler Turn Downs are Mandrel bent and aluminized. If you need 2.5" Turn Downs, just purchase a 90degree Elbow and cut it in half in the middle of the bend. See Elbows.
| 3" | MFTD30 | $25 ea |
| 3.5" | MFTD35 | $25 ea |
Question?
or Request our Catalog
See
Links Below
(Please give vehicle, engine and year & any other pertinent info so we can answer your question and send the correct information)
"All performance
exhaust products for pollution controlled vehicles are intended for off-road or
drag strip use only"
Copyright © 2002-2010, Torque Tech & Co., Inc. All rights reserved.
Page Last Updated:
06/12/2010